JRC JLR-7500 User Manual (English)

Other manuals for JRC JLR-7500

Instruction Manual216 pages

Brochure6 pages

Questions and Answers:

C
Carrie PattersonJul 30, 2025
What to do if my JRC JLR-7500 power does not turn on?
- L
  Larry KnightJul 30, 2025
  If your JRC GPS unit isn't powering on, there could be several reasons. First, check the cabling from the junction box to ensure power is being supplied. Also, verify the power supply unit cabling if you're using optional power supply equipment. If the cabling is fine, inspect the fuse connected to the power cable and the fuse in the optional power supply equipment, replacing them if blown. If none of these steps work, the display unit switch might be broken, in which case you should consult with JRC or an affiliate.
M
Melissa ReidAug 3, 2025
Why is my JRC JLR-7500 not receiving signal from the sensor?
- K
  Katherine HeathAug 3, 2025
  If your JRC GPS isn't receiving a signal from the sensor, the issue might be a cut sensor connection cable, so check the cable. If the cable is not the problem, the sensor itself may be broken, and you should consult with JRC or an affiliate.
C
Cody MeadowsAug 7, 2025
What to do if my JRC GPS has no reception from external devices?
- O
  ofosterAug 7, 2025
  If your JRC GPS is not receiving data from external devices, the polarity of the serial cable might be incorrect, so check it. Also, the interface settings might not match; ensure they are correctly configured. Finally, an unsupported sentence may have been entered; verify the entered commands and version.
A
ashley73Aug 11, 2025
How to troubleshoot no transmission to external devices on my JRC JLR-7500 GPS?
- G
  Gregory OdonnellAug 11, 2025
  If your JRC GPS is not transmitting to external devices, the output settings may not be configured correctly; you should refer to section 4.20. The configured channel might also be incorrect; refer to section 4.20. If these settings are correct, the DISP-DPU or connector board might be broken, and you should consult with JRC or an affiliate.
K
kbondAug 16, 2025
Why is there no alarm sound on my JRC GPS?
- M
  Michael EvansAug 16, 2025
  If the alarm sound is not working on your JRC GPS, the buzzer itself may be broken, and you should consult with JRC or an affiliate. Alternatively, the alarm sound may be turned off, so refer to section 4.11.2 for setting the alarm sound.
T
toddkhanAug 20, 2025
What to do if the LCD display on my JRC GPS is not working?
- K
  Kathryn HancockAug 20, 2025
  If the LCD display on your JRC GPS is not displaying anything, the LCD display may be broken, and you should consult with JRC or an affiliate.
J
John AustinAug 25, 2025
How to enable the click sound on my JRC JLR-7500 GPS?
- T
  tonya67Aug 26, 2025
  If the click sound is not working on your JRC GPS, the key press sound may be turned off. Refer to section 4.14.3 for setting the Click sound.

JRC JLR-7500 Specifications

General

Type	GPS Receiver
Update Rate	1 Hz
Frequency Range	1575.42 MHz (L1)
Velocity Accuracy	0.1 m/s
Operating Temperature	-15°C to +55°C
Channels	12
Position Accuracy	2.5 m CEP
Time Accuracy	1 μs
Operating Voltage	12 V DC