JRC VDR JCY-1900 - Starting the VDR; S-VDR System; Powering On Procedure; System Status Indicators (LEDs); Startup Screen Display

2. Starting the VDR / S-VDR
1) Unlock and open the front door.
2) Turn on the POWER switch.
3) After approximately 2 minutes, make sure that the MCB’s LED (SYS, REC) lights up in green.
4) The OPU starts up and displays the startup screen.
5) Close and lock the front door. Please keep the key carefully.
3. Stopping the VDR / S-VDR
1) Unlock and open the front door.
2) Turn off the POWER switch.
3) After approximately 1 minute, make sure that the MCB’s LED goes out.
4) Check that the OPU’s screen disappears.
5) Close and lock the front door.
POWER switch
Do not stop the VDR / S-VDR, except the following case.
●During essential maintenance whilst the vessel is in port.
●When the vessel is laid-up.
●Upon request by an investigation authority, for example
after the vessel had been involved in a marine incident.
Startup screen
SYS
REC
拡大
LED position
POWER switch
4. HOME screen
Button
Function
Description
Alert
Checking the
alert
Display the ALERT screen. Check the
alerts that are occurring.
Check
Checking the
recorded data
Display the DATA CHECK screen.
Check the connected units to the VDR
system.
Copy
Copying the
recorded data
Display the DATA COPY screen. Copy
the recorded data to the USB flash
drive.
Setup
Setting up the
system
Display the SETUP screen. Check the
VDR system settings and information.
Gyro I/F
Setting the
initial ship's
heading
Display the GYRO I/F screen. Enter the
initial value of the ship's heading.
5. Operation guide when a maritime accident occurred
Tap the [PROTECT] button in the “Save the recorded
data at marine accident case” screen.
Check that the data and time of [Accident time] field in
the DATA PROTECT screen is the current time.
[Information]
It is not usually necessary to change because the current
time is set automatically.
Tap the [Protect] button to preserve the recorded data.
Tap the [Save] button in the HOME screen.
Preserving the recorded data
1)
2)
3)
4)
When a maritime accident occurred, please secure
the “Save area” as the recorded data can be
preserved immediately. The “Save area” are three
area.
HOME screen