!
DON'T OPERATE
KEEP PLUG DRY.
FOR SAFETY PUT
IF PUMP SUBM-
POWER BREAKER.
ERSED BY SAND.
Installation & Operating Instructions
Range of Sumbersible Pumps are suited for the small to medium De-watering (or recir-
culating) applications.
They are extremely quiet in operation which makes them ideal for applications within residential
areas for sullage pits, pool emptying, waterfalls and general drainage.
Other ideal applications are:
Lift Wells
Car Park Sumps
Basements
Cable Pits, etc.
This. Submersible Pump has been factory checked prior to delivery; however, please
check for any damage during transport.
Sales and service is available from Pumps or Authorised Dealers.
Do Not
•
Lift the pump by the motor lead
•
Run the pump dry
•
Attempt electrical repairs
•
Run the pump with the motor fully exposed for long periods
•
Install the pump on soft or loose ground
CAUTION:
ft
%
-
'4
DON'T LIFT OR
CARRY THE PUMP
BY POWER CABLE.
Installation
The Pump is completely submersible and should be placed on a solid fiat surface
(if not available sit the pump on timber or house bricks) in the vertical position. Automatic
versions should be placed in a sump which has adequate dimensions so as not to restrict
the movement of the float switch.
AUTOMATIC PUMP has been factory set to provide the correct ON-OFF switching mode.
Always use the biggest diameter hose possible, a better flow is obtained and the pump will
work easier. All hose can be obtained from our factory if required.
This pump is not a slurry pump, It cannot pump stones.
18TH EDITION lEE REGULATIONS. ALWAYS USE A POWER BREAKER WITH
OUTSIDE ELECTRICITY. IF IN DOUBT CONSULT AN APPROVED NICEIC
ELECTRICTIAN.
To Next Page
Need help?
General