28
Push and hold the “SET” button to enter the
setting mode. Push the ▲/▼ button to choose
to set RX (receiver) or TX (transmitter).
Parameter setting
When RX receiver is selected:
◎ FREQ: frequency setting
In 1MHz Select frequency with ▲/▼
In 0.025MHz Select frequency with ▲/▼
Select the number of frequency rst in MHz and
then in 0.025MHz.
◎ Group / channel
G: group Select default group 1~6
CH: channel Select default channel, 1~22 max
Select the group when “G” is ashing; select the
channel when “CH” is ashing.
◎ Channel scan
SC oFF This means the function is deactivated.
SC on This means the function is activated.
(scan to make sure this channel is oc-
cupied or not) The program will avoid it
automatically to prevent interference.
This function is deactivated.
Note: this function works only in the preset mode.
6-1-3 How to use //
To Next Page
Loading...
Need help?
General
