30
Push and hold the “SET” button to enter the setting
mode. Push the ▲/▼ button to choose to set RX
(receiver) or TX (transmitter).
Parameter setting
When RX receiver is selected:
◎ FREQ: frequency setting
In 1MHz Select frequency with ▲/▼
In 0.025MHz Select frequency with ▲/▼
G: group Select default group 1~6
CH: channel Select default channel,
1~22 max
Select the number of frequency rst in MHz and
then in 0.025MHz.
◎ Group / channel
Select the group when “G” is ashing; select the
channel when “CH” is ashing.
◎ Channel scan
SC oFF This means the function is deactivated.
SC on This means the function is activated
(scan to make sure this channel is occu-
pied or not. The program will avoid it
automatically to prevent interference.
This function is deactivated.
Note: this function works only in the preset mode.
6-3 How to use //
To Next Page
Loading...
