8
Step 3. Enter a new programming protection passcode 8888
and . The keypad will sound a long beep followed by a short
beep to confirm the new passcode has been programmed.
Step 4. Programming the channel 2 entry passcode, please
reference the above operation. The Step 2 operation is
enter 02 and .
● Programming protection passcode setting
● Entry passcode setting for channel 1 and channel 2
For this example, we will use 5555 as channel 1 entry
passcode.
3. In any channel, if the passcode quota is out, the red
light will blink 5 times and exit. However, if user still
operate to add a new entry passcode, the keypad
will delete the first passcode from the channel,
and save the new passcode as the last passcode.
1. Factory default, 01 is channel 1, 02 is channel 2.
If you entered 01, you will be using passcode channel
1, which stores up to 8 passcodes. lf you entered 02,
you will be using passcode channel 2, which stores
up to 3 passcodes.
2. lf you hear no beep and see the red light blinks 5 times,
that means the passcode you entered already exists
and the keypad will automatically exit the passcode
setting mode.
Step 2. Enter 01 and . The keypad will sound a beep.
Step 3. Enter a new entry passcode 5555 . The keypad will
sound a long beep followed by a short beep, confirm
the new entry passcode has been saved for channel 1.
Step 1. Enter new programming protection passcode 8888 .
To Next Page
Loading...