JUKI 6100 - Disassembly and Assembly

86 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

5.2

Disassembly

and

assembly

The

following

describes the

disassembly

procedures for

the main parts

of the

printer.

Unless

otherwise

described,

assemble

the

parts in reverse order

from

disassembly

procedures.

CAUTION:

BEFORE

PROCEEDING

WITH

ANY OF THE

REMOVAL/

REPLACEMENT

PROCEDURES

YOU

SHOULD TURN

THE

PRINTER

OFF

DISCONNECT

THE POWER

CORD

AND

UNPLUG

THE

INTERFACE

CONNECTOR.

NOTE:

All

procedures

outlined

in the

removal/replacement

section of

this

manual assume

that the

tractor

assembly

is not present on

your

printer.

For

tractor

removal see

your

tractor

installation manual.

5.2.1

Removing

the covers

(Refer

to

Fig. 5.1

on

Page

10 and

Page

13)

(

1 )

Top

cover

and acoustic

cover

assembly

(T)

To

remove

the top

cover and

acoustic

cover

assembly

simply pull up

along

the

front

edge until

it disengages

from

the

center cover assembly.

Once the

front

edge is

free, pull up

along

the

front edge until it

disengages from

the

center

cover

assembly. Once

the

front

edge is free, pull the top

cover

toward you to

completely remove

it.

(2)

Removing

the center

cover

(2)

Step

1. Move the

carriage to the

center of the

platen.

Step 2.

Move

the paper guide

to the

far

left and then turn the

paper

table

toward

the rear of

the

machine.

Step 3.

Pull the

paper

release lever

to the

forward

(released) position.

Step

4. To

remove

the platen

assembly,

locate the

two black

plastic platen

bearings. On

each bearing

there

are two

protrusions. Pinch

the two

protrusions

together

while

gently pulling

the platen away

from the

frame.

Repeat this

procedure

for both ends

of the platen.

Step

5.

Remove two

screws

(§)

which

are located

just below the

area

where the

platen

knobs

exit the cover.

Step

6.

There are 5

points

( )

along

the

front edge of the

center

cover

which must

be

disengaged

from the bottom

cover.

Reach

points

designated to

detach

the

five clasps.

Step

7.

Slowly

lift

the

front

of the

center

cover and push

toward the

rear

to

disengage the

last 3

clasps.

Lift the

cover away from

the

printer

assembly.

(3)

Removing

the

bottom cover

(4)

Step 1

. Move

the carriage as

far to

the

left as

possible.

Step

2.

Locate two

ribbon

cable

assemblies, 1

center and 1

far right in

the

base

of the

printer.

Remove

and

retain two

pieces

of

tape

from

each

of the ribbon

cable

assemblies.

-

9

-

Other manuals for JUKI 6100

Operation Manual51 pages