JUKI 6100 - 6 Adjustment

(3)
Light printing
with
or without
cut-off over entire
print
line.
a.
Check linear motor rail to carriage frame
adjustment. (Maintenance
Section Page
34)
b.
Check hammer unit positioning. (Maintenance
Section Page
36)
c.
Perform motor
bracket
adjustment
(Left and right sides)
d.
Replace hammer unit. (Refer to
Removal/Replacement Section)
e. Replace
SCU board. (Refer to
Removal/Replacement Section)
(4)
Light printing on one end with or without
cut-off.
a.
Check
that platen is fully seated on
both ends.
b.
Perform motor bracket
adjustment.
c.
Remove or
insert
motor rail spacers as needed.
(5)
Tilted print
line
with
or without cut-off on
one end.
a.
Check that platen is fully seated on both
ends.
b.
Remove or insert motor rail spacers as needed.
c.
Perform motor
bracket
adjustment.
Fig.
6.9
-
38
-