– 12 –
(5) Adjusting the position of the thread receiver
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
Standard adjustment
1. Position of the needle bar thread take-up thread receiver (in case of standard seams)
(1) It is the standard that the height of needle bar thread take-up thread receiver
❶
is in the position
where the bottom end of thread hole to the center of needle bar thread take-up
❷
aligns with the top
surface of needle bar thread take-up thread receiver
❶
when the needle bar is in its lowest position.
Thread hole
Center of hole
This range
To align
To Next Page
Loading...
Need help?
General
