ENGLISH
23
The base where the pool heat pump is positioned must be flat, as it is to be installed horizontally.
The pool heat pump’s location must be suitable for cable routing and pipe connections.
Wait 12 hours after the unit has been installed and connect to the mains before test running the
unit.
IMPORTANT!
Avoid installation/operation of the pool heat pump
where the leakage of inflammable gases can occur or where flammable gas is stored
in the vicinity of bedroom windows
where the mains supply is unstable
where there are strong electromagnetic fields.
Place the pool heat pump so that it does not disturb the surroundings and preferably fit a protective
cover over the unit.
OPERATION
Operating setting
Use of the control panel
1. When the unit is connected to voltage the display shows the outdoor temperature.
2. Start the unit by pressing
. The unit then shows the incoming and outgoing water
temperature.
LCD display
Press to switch the
unit OFF/ON.
The unit only runs in
default mode and
cannot be chan
ed
Press at the
same time to access settings.
Temp. - outdoors
To Next Page
Loading...
