Jula HAMRON 005017 - Safety Instructions; Symbols; Product Description; Package Contents

EN
23
DESCRIPTION
Package contents:
• Monitor
• Camera with mounting plate
• 12/24 Volt cable
• Holder with double-sided tape
• Installation accessories
– cable ties
– screws and nuts
– connector
– cable bush (3 dierent)
– straps
MOUNTING
NOTE:
This product is universal. The instructions
are therefore a guide and do not apply to all
vehicles. For specic questions concerning
vehicle, contact the vehicle manufacturer.
INSTALLATION
Positioning the camera
The camera should be placed on the rear end
of the vehicle. The most practical solution is
to mount the camera near the number plate
if possible. A mounting plate that can be
fastened behind the number plate is included,
and is mounted on the camera.
Mounting the camera
NOTE:
• If necessary get an automotive
electrician or other qualied person to
connect to the vehicle’s electrical system.
• Never route the cable on the outside of
the vehicle.
SAFETY INSTRUCTIONS
Read all the instructions before installation.
Symbols
Approved in accordance with
the relevant EU directives.
Read the instructions.
Recycle as electrical waste.
TECHNICAL DATA
Monitor
Operating voltage 8–30 V DC
Power consumption, standby ≤ 70 mA
Power consumption, operation ≤ 380 mA
Monitor, width 18 cm (7")
Monitor, resolution 800 x 480 px
Temperature range -10 to 50˚C
Camera
Operating voltage 8–30 V DC
Power consumption ≤ 300 mA
f-number, optical lens f/2.0
Image sensor CMOS 640 x 480 px
Transmit frequency 2.4 GHz
Range WiFi* ≤ 100 m
* Max distance for wireless transfer between
camera and monitor.