Jula HAMRON 005017 - Starting and Using the Monitor; Pairing Camera and Monitor; Monitor Settings: Auto Display and Mirror

EN
26
Unpairing
To unpair, press the "Menu" button and select
SETUP - VERSION. Press the “Up/Auto mode"
button for ve seconds. "mac address erased"
will then be shown on the monitor.
Two cameras
The system supports up to two cameras. These
should be paired together at the same time
and in the same way as using one camera.
After pairing use the arrow buttons to select
which camera view to show on the monitor.
FIG. 9
Setup
Use the arrow buttons to set AUTO DISPLAY,
MIRROR and VERSION.
FIG. 10
Auto display
By activating AUTO DISPLAY the monitor
automatically shows the camera or cameras
preselected in the menu, when the vehicle is
put in reverse gear.
1. Use the arrow buttons to select whether
to show CAM 1, CAM 2 or both on the
monitor.
2. Activate the function by pressing the “Auto
mode” button.
Mirror
The MIRROR function (image reversal) makes
it possible to mount the camera over or under
the number plate and then show the image
correctly on the monitor.
1. Use the arrow buttons to select which
camera is to be mirrored.
5. Guidelines
6. Power switch OFF/ON
START THE MONITOR
1. Press the power switch to start the
monitor.
2. An image is shown automatically on the
monitor when the vehicle is put in reverse
gear and a blue LED indicates that the
function in active. This is assuming the
units have been paired, see PAIRING.
NOTE:
If the monitor is supplied with power but no
image is shown, the blue LED will ash instead.
If the blue LED is o this means the monitor is
either switched o or without power.
MENU
Press the "Menu" button to go to the functions
PAIRING, SETUP and PICTURE.
FIG. 8
Pairing
Pairing is used to connect the wireless units
together.
1. Select PAIRING with the arrow buttons and
conrm by pressing the “Conrm” button.
2. Now press the rubber coated button on
the underside of the camera until the
signal is received by the monitor and the
symbol
is shown on the display. The
units are paired together, which in future
will take place automatically.
3. Press the "Menu" button to exit, or
wait 30 seconds for this to take place
automatically.