1. Turn the gas cylinder valve (clockwise) to the full OFF
position.
2. Detach the gas hose from the gas cylinder.
3. Remove burner from the bottom of the BBQ. Use a
screwdriver.
4. Carefully lift burner up and away from the BBQ.
5. Refer to below and perform one of these three
cleaning methods.
BURNER MAINTENANCE
Bend a stiff wire, (a lightweight coat hanger works
well) into a small hook. Run the hook through the
burner tube and inside the burner several times to
remove any debris.
Use a bottle with a flexible handle. Run the brush
through the burner tube and inside the burner
several times, removing any debris.
Use an air hose to force air through the burner
tube. The forced air should pass debris or obstruc-
tions through the burner and out the ports.
IMPORTANT INFORMATION
Inspect burner after installation and check to ensure
it is securely tightened to the base and injector is
centred inside the burner as you found it.
Regardless of which burner cleaning procedure you
use, we recommend you also complete the following
steps to help prolong burner life.
You should check the burner periodically for any sort of
blockage. Use a wire brush to unclog the holes.
To reduce the chance of “FLASH-BACK”, the procedure
below should be followed at least once a month in late
summer or autumn when spiders are most active or
when your BBQ has not been used for a period of time.
1. Use a wire brush to clean the entire outer surface
of each burner until free of food residue or dirt.
2. Clean clogged ports with wire, such as an open
paper clip.
To Next Page
Loading...
Need help?
General
