NATURAL GAS CONVERSION INSTRUCTIONS
This kit is only compatible with BBQ models listed on the table within
this instruction manual. Check your BBQ model is listed BEFORE
undertaking gas conversion using this kit.
Contents of this conversion kit
6 x 1.62mm Short injectors
6 x 1.65mm Short injectors
1 x 1.50mm Long injector
1 x 1.50mm Short injector
1 x 30cm Natural Gas hose
1 x brass fitting (Hose to Natural Gas regulator)
1 x Natural Gas regulator
1 x Ground fixing bracket and fasteners
1 x Natural Gas sticker
This kit does NOT include the gas line from supply point to the regulator inlet as each installation will
require a different length, connection type and diameter to meet gas flow requirements.
Introductory Statement
Your BBQ has been configured for use with LPG from a gas cylinder. If you want to connect
your BBQ to a permanent Natural Gas supply, the following steps must be undertaken.
1. Contact a licensed plumber or gas fitter and arrange a quote to convert your BBQ to
Natural Gas and supply any pipework necessary to bring a natural gas supply line to the BBQ
installation area. All works must be made in accordance with AS5601.1.
2. Undertake conversion to Natural Gas using these instructions and the parts contained in
this kit.
3. Obtain a certificate of compliance from your licensed gas fitter.
IMPORTANT: Refer to the instruction manual provided with your BBQ for installation
clearances.
Version 7
Release 9/11/2021
Page 1
NG Conversion Instructions
Suits Jumbuck models Stardom, Stardom II, Comet, Comet Plus & Astro only
To Next Page
Need help?
General
