2. Turn off
gas valves
3. Turn gas cylinder
on
4. Spray or apply
soapy water on
gas connections
5. If leak is
present, bubbles
will appear
LEAK TESTING
LEAK TESTINGLEAK TESTING
LEAK TESTING
Please check for gas leakage the first time you are
connecting the gas oven to the gas cylinder, and
also each time you are replacing the gas cylinder or
disconnecting/reconnecting any fittings. Inspect
the hose before each use.
To check for gas leakage, turn on the gas supply at
the gas cylinder, but do not switch on the burner
inside the gas oven. The gas hose will now be filled
with gas. Then pour water with soap over all
connections. Any gas leakage should result in
bubbles within 20 seconds. If a gas leakage is
detected, tighten the connection. If the gas leakage
persist, contact your supplier or place of purchase.
As an alternative, you may use a gas leak detector,
following the manufacturer’s instructions, available
at all major BBQ retailers. This provides an easier
way to check for gas leaks
DO NOT USE NAKED FLAME FOR LOCATING
DO NOT USE NAKED FLAME FOR LOCATINGDO NOT USE NAKED FLAME FOR LOCATING
DO NOT USE NAKED FLAME FOR LOCATING
GAS
GAS GAS
GAS
LEAKS.
LEAKS.LEAKS.
LEAKS.
IF A LE
IF A LEIF A LE
IF A LEAK PERSISTS, CALL AN
AK PERSISTS, CALL AN AK PERSISTS, CALL AN
AK PERSISTS, CALL AN
AUTHORISED
AUTHORISED AUTHORISED
AUTHORISED PERSON
PERSONPERSON
PERSON
1. Add soap and water to spray bottle or
soapy water with brush
To Next Page
Loading...
Need help?
General
