85
6 Annex
6.4 Barcode
Initializing the barcode scanner
The barcode scanner must be initialized once prior to use. Example:
The relevant information and barcodes can be found in the manual for the barcode scanner being used.
The paperless recorder supports the barcodes code 39 (standard variant) and code 128 (A and B, with-
out control characters) as well as the QR code (without control characters). The following examples were
drawn up using code 39.
6.4.1 Batch control
NOTE!
In order to control batches using the barcode scanner, the paperless recorder must have been config-
ured accordingly. The "Enter batch texts" right is required.
Showing the batch report
This function requires the corresponding display configuration (Configuration > Display > General:
Barcode -> Batch mask = Yes).
The batch report of the selected batch is displayed.
Step Action
1 Scan the "Factory Default Settings" barcode.
2 Scan the "Select RS-232 Standard" barcode.
Step Action
1 Scan the barcode of the batch concerned (e.g. BATCH1 for batch 1).
To Next Page
Loading...
