higher pressure;
(3) When the pulse is measured, the screen will display the “heart”
symbol and start flashing. The flashing “heart” symbol will be displayed
on the screen.
(4) Upon measurement completion, the measured values of systolic
pressure, diastolic pressure and pulse will be displayed on the screen.
(5) The screen will continue to display the measurement results, unless
you press on the “Power ” button to turn off the device. If there is no
operation, the device will be powered off automatically in 30s.
4.3 Using memory function
This blood pressure monitor is available for 2 users with 199 memories
per user,and the guest mode does not save the measurement data. If the
199 groups of memory data are full, they will be replaced automatically.
After the blood pressure monitor has been used for several times, in the
OFF state, you can press the “Memory ” button to display the latest
measurement result, and track the rest data one by one via pressing the
“Memory ” button.
4.4 Clearing stored measurement data
In the shutdown state, long press the "Memory " key for 3 seconds,
and then long press the "User " key for 3 seconds until " " is
displayed in the high-voltage area and " " is displayed in the
low-voltage area, thus all of the memory values of the current user are
deleted.
To Next Page
Loading...
