Jumpking Oval POD - Joining Frame Halves

8
You will need two people for this next step.
C
E
E
B
B
D
A
A
D
F
F
C
Insert 1 end of W-leg partially into Connector A.
Next place feet either side of POD-Connector B.
Then pull other end of W-leg into POD-Connector B.
(You will need to use force for this step)
Now push down on W-leg so inserted fully in each
POD-connector.
Repeat with other W-Legs
Now you have 4 completed segments
2 x Assembly 1 (ABC)
2 x Assembly 2 (DEF)
B
C
F
A
B
C
D
E
F
E
D
Turn over 1 x Assembly 1 (ABC) and 1 x
Assembly 1 (DEF)
Join by inserting C into POD-connector
D. (Make sure spring hole lines up with
gap in connector)
Repeat this step so you are left with 2
halves of Trampoline
Carefully join the 2 halves together.
For the last section, you will need
someone to stand on the opposite side
if the frame and push towards you
whilst you insert Top-rail into POD-
Connector.
A