JumpPro Xcite - STEP 4: FITTING THE FRAME PAD; Lay the frame pad sections (A) over the edge of the frame with the ties facing downwards.; Connect the sections together with the attached hook and loop sections.; Tie all the black straps onto the top rails. Do not tie them to the springs.

12
9. To even out the tension and avoid over stretching the springs, continue connecting every few
springs in the above sequence until all springs are attached by using spring pulling tool (N).
STEP 4: FITTING THE FRAME PAD
10. Lay the frame pad sections (A) over the edge of the frame with the ties facing downwards.
11. Connect the sections together with the attached hook and loop sections.
11
10
9
12
17 13
14 18
20 16
15 19