E-MAIL MESSAGING 8
4.3 Action create email messaging
Last of all you create an action which sends you an email message if a leakage is found.
1. In SV Control, go to Actions.
2. Create a new leakage email message
action [1] for the function you have
just created.
3. In the edit action [2] field, allocate the
action to an area.
4. Now select an action type [3], in this
case event-dependent.
5. Now select a symbol for the leakage
email message.
6. Select an action trigger [4], in this
case leakage sensor.
7. Select the condition for triggering [5],
in this case With every ON.
8. Under Add function to action [6],
select the email message you created
previously.
1
2
4
6
5
3
To Next Page
Loading...
