33 32
Your Junghans multi-frequency radio-controlled solar-powered watch
is able to automatically pick up time signals from the following trans-
mitters:
– DCF77 in Mainingen (24km south of Frankfurt am Main) for
Europe,
– JJY40 on Mount Ohtakadoya (near Tokyo in the North East of the
country) for Japan
– JJY60 on Mount Hagane (in south-western Japan) for Japan and
South Korea
– WWVB in Fort Collins, Colorado (USA) for America
As a consequence, the Junghans multi-frequency radio-controlled solar
watch always displays absolutely precise time in these 4 transmission
areas, provided reception is good. The Junghans multi-frequency
radio-controlled solar watch synchronises itself daily automatically
with the DCF77, JJY40, JJY60 and WWVB time signal transmitters. In
the event of reception being disrupted (e.g. due to storms, electrical
devices, light dimmers), the Junghans multi-frequency radio-controlled
solar watch restarts an attempt at reception on the following day at
the same time. A manual time synchronisation can also be performed
via a transmitter call, e.g. at a place with better reception conditions.
The most recently received time information is saved in an internal
memory. This continues on a highly-accurate 32 kHz quartz basis until
the next time synchronisation. The radio-controlled time synchroni-
sation of your Junghans multi-frequency radio-controlled solar watch
not only ensures consistently precise time display. The switch from
CET to CEST – and reverse – is also performed automatically for the
Junghans multi- frequency radio-controlled solar watch where undis-
turbed reception is available (at night). If you travel to a country with
another time zone, the time zone setting of the Junghans multi-fre-
quency radio-controlled solar watch enables the time to be set simply
to the respective local time zone.
To Next Page
Loading...
