39 38
5. Selectable LC displays
The LC display is showing the date. By briey pressing button T1, you
can activate the reception indicator. After 3 seconds, the display swit-
ches back to the date.
If the charge level is low, the LC display shows the seconds (ashing
alternately with [Lo]). The second hand stops at the 12 o’clock position.
6. Reception indicator
The reception indicator shows you whether synchronisation has taken
place with one of the time signal transmitters. It can display the four
following codes:
EU = DCF 77 (Europe)
JP = JJY 40 (Japan)
JP. = JJY 60 (Japan)
US = WWVB (USA)
If a time signal transmitter is shown on the LC display, the watch has
picked up the signal during the overnight automatic time synchronisa-
tion. If all that is shown on the LC display is two bars, poor reception
conditions have resulted in no automatic synchronisation taking place.
After the next successful synchronisation, the relevant time signal
transmitter will once again be indicated.
Please note that no time synchronisation occurs in quartz mode (see
chapter 6.3).
Analogue display: hours, minutes, seconds
LC display: date, reception indicator, charge level indicator
Button T1: press briey: reception indicator
press for > 3 seconds: transmitter call
Button T2: time-zone settings
To Next Page
Loading...
