4.10.3 Depositing a load
CAUTION!
Loads must not be set down on transport or escape routes, in front of safety
installations or factory equipment that must be accessible at all times.
Requirements
– Storage location suitable for storing the load.
Procedure
• Drive the truck carefully up to the storage location.
• Lowers the load handler.
Z
To avoid damaging the load and the load handler, avoid setting the load down
abruptly.
• Lower the load handler so that it is clear of the load (see page 95).
• Carefully drive the load handler out from beneath the pallet.
The load is deposited.
NOTICE
Avoid depositing the load suddenly to avoid damaging the load, load handler and the
rack.
NOTICE
The "soft landing" feature reduces the lowering speed of the load just before it
reaches the ground (approx. 100 - 300 mm).
Z
The “soft landing" feature is an optional extra.
Two palletised loads transported on top of each other can only be lowered if the
corresponding optional equipment is available, see page 104.
100
04.19 en-GB
To Next Page
Loading...
Need help?
General
