Juniper Mesa 3 - Display and Touchscreen Settings

8 Mesa 3 Rugged Tablet Owner’s Manual
Standard Features
This chapter discusses the standard features included with
every model of the Mesa 3 Rugged Tablet™ with Windows
10 Pro.
Display and Touchscreen
The Mesa 3 has a bright color display and capacitive
touchscreen with a diagonal viewing area of 7 inches
(178 mm).
Display and Touchscreen Prole Settings
Display Settings
To adjust the display settings including the text size,
brightness, and orientation, go to the Action Center and
select All settings > System > Display.
Backlight Brightness
There are a few shortcuts to adjust the display backlight
brightness.
Open the Action Center. Tap the percent tile (sun icon) to
toggle the display backlight brightness up or down in 25%
increments from 0% to 100%. This same tile can be accessed
by tapping the battery icon on the desktop. To simply dim
the backlight, tap the Battery saver tile. Tap it again to
return it to the previous brightness.
Touchscreen Prole Settings
To adjust the touchscreen prole, go to the Start menu and
select Touchscreen Proles. Select the touch prole you
want the screen optimized for: Finger and Stylus (default),
Finger, Stylus, Wet, or Glove. As the new prole loads, a
progress bar is shown. Do not interrupt the loading process.
You can try different proles to see which one works best.
Using the Mesa 3 in Wet Conditions
When using the Mesa 3 in wet conditions, you must use
your nger or the soft-tipped stylus that is included on the
capacitive touchscreen, even if the Wet touchscreen prole
is selected. The hard-tipped stylus is not supported with the
Wet touchscreen prole. Third party styli may work with the
Mesa 3 touch screen, however, performance may vary.