EasyManuals Logo

Juniper PTX User Manual

Juniper PTX
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Step 2: Up and Running
IN THIS SECTION
Set Parameter Values | 4
Perform the Initial Configuration | 4
Set Parameter Values
You must perform the initial configuration of the optical ILA through the console port. Before you begin, set the following
parameter values from the console server or PC:
Baud Rate—115200
Flow Control—None
Data—8
Parity—None
Stop Bits—1
DCD State—Disregard
Perform the Initial Configuration
To connect and configure the optical ILA from the console:
1. Connect the console port to a laptop or PC by using the provided RJ-45 cable and RJ-45 to DB-9 serial port adapter.
The console (CON) port is located on the management panel of the optical ILA.
2. Log in as the root user. Enter the default password root.
login: root
3. Start the command-line interface (CLI).
root@% localhost:~# /usr/bin/command
Welcome to ILA World
BPS>
4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper PTX and is the answer not in the manual?

Juniper PTX Specifications

General IconGeneral
BrandJuniper
ModelPTX
CategoryAmplifier
LanguageEnglish

Related product manuals