Juniper PTX User Manual

Quick Start Guide
PTX Optical Inline Amplifier
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 4
Step 3: Keep Going | 5
Step 1: Begin
IN THIS SECTION
Mount the Optical ILA | 2
Connect Power to the Optical ILA | 3
To install and configure a Juniper Networks Optical Inline Amplifier, you need:
•
Electrostatic discharge (ESD) grounding strap (not provided)
•
Four screws to secure the chassis and mounting brackets to the rack (not provided)
•
Screwdriver appropriate for the rack-mounting screws (not provided)
•
Two power cords with plugs appropriate for your geographical location (provided with the AC model)
•
Two DC power connectors (provided with the DC model)
•
Power cable or cables appropriate for your geographical location available to connect DC power to the optical ILA (not
provided)
•
RJ-45 cable and RJ-45 to DB-9 serial port adapter (provided)
•
Management host, such as a PC laptop, with a serial port (not provided)

Juniper PTX Specifications

General

Brand	Juniper
Model	PTX
Category	Amplifier
Language	English

Summary

Step 1: Begin

Mount the Optical ILA

Instructions for mounting the optical ILA onto a two-post rack using the provided mounting kit.

Connect Power to the Optical ILA

Steps to connect AC or DC power supplies to the optical inline amplifier for operation.

Step 2: Up and Running

Set Parameter Values

Configure console server or PC parameter values before performing initial configuration.

Perform the Initial Configuration

Connect to the console port and log in to perform initial configuration via the command-line interface.

Step 3: Keep Going

Safety Warnings Summary

Summary of safety warnings for installing and operating the optical ILA components.