Juniper Networks SSG 320M and 350M Security Policy
Figure 4: Front of the SSG 350M device
Figure 5: Rear of the SSG 350M device (inverted)
Figure 6: Corner of SSG 350M device showing detail of label #10
Tamper-evident seals should be applied to:
The front of the 350M, as shown in Figure 3 (8 seals):
o Label #1 vertically from the removable cover on the top of the device across the left
edge of the two leftmost slot covers.
o Label #2 vertically, overlapping the lower ¼ inch of label #1, extending from the
middle slot cover on to the front of the chassis.
o Label #3 vertically from the removable cover on the top of the device across the right
edge of the two leftmost slot covers.
o Label #4 vertically, overlapping the lower ¼ inch of label #3, extending from the
middle slot cover on to the front of the chassis.
o Label #5 vertically from the removable cover on the top of the device, across the left
edge of the rightmost two slot covers.
o Label #6 vertically, overlapping the lower ¼ inch of label #5, extending across the left
edge of the lower slot cover on to the bottom of the chassis.
To Next Page
Loading...
