Need help?Do you have a question about the Juniper CTP Series and is the answer not in the manual?
General| Dimensions | Varies by model |
|---|---|
| Weight | Varies by model |
| Product Series | CTP |
| Port Density | Varies by model |
| Supported Protocols | Ethernet |
| Power Supply | Redundant, hot-swappable |
| Management | CLI, SNMP |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
Details the different types of bundles and their applications and supported interfaces.
Explains the Serial Multiservice Interface module and its supported modes.
Explains the goal and types of adaptive clocking for CTP bundles.
Discusses factors for determining optimal IP packet size for CTP bundles.
How to provide Quality of Service (QoS) for CTP bundles using service type.
Introduces transparent encoding and its applications, including modes and recommendations.
Explains Time Division Multiplexing (TDM) and Time Domain Correlation (TDC) features.
Steps to add a bundle using the CTPView interface.
How to set IP parameters for CTP bundles in CTPView.
Guide to configure advanced circuit startup options in CTPView.
Steps to configure the circuit direction for CTP bundles in CTPView.
How to configure serial port parameters for CTP bundles in CTPView.
How to configure transparent encoding for CTP bundles in CTPView.
How to configure high-speed and low-speed bundles for TDM/TDC operation.
How to configure T1 and E1 port parameters for CTP bundles in CTPView.
How to configure multiservice audio mode port parameters for CTP bundles.
How to configure multiservice IRIG-B mode port parameters for CTP bundles.
How to configure port parameters for IRIG-B daughter cards in CTPView.
How to configure adaptive clocking attributes for CTP bundles in CTPView.
How to configure NetRef settings for node synchronization in CTPView.
How to change bundle status (activate, disable, delete, recenter) via CTPView.
How to change bundle status using the CTP Menu interface.
How to view bundle configuration, state, and counters in CTPView.
How to view NetRef node synchronization details using the CTP Menu.
How to view bundle configuration, state, and counters using the CTP Menu.
How to use SCC counts to monitor packet creation and reception via CTP Menu.
How to use buffer sampling to monitor packet delay via CTP Menu.
Overview of using serial loops for diagnosing network issues.
Overview of performing Bit Error Rate Tests (BERT) on bundles.
Overview of setting up end-to-end BERT tests for CTP bundles.
Steps to configure serial loops using CTPView.
Steps to configure BERT tests using CTPView.
How to view BERT status and counters in CTPView.
How to view BERT status and counters in the CTP Menu.
How to reduce SNMP traps for late and missing packets using CTP Menu.
To Next Page
