Juniper CTP Series - Configuring BERT Testing for CTP Bundles (CTP Menu)

Configuring BERT Testing for CTP Bundles (CTP Menu)
BERTs do not run on bundles that use transparent encoding or on fractional T1/E1 bundles.
To configure BERTs with the CTP Menu:
1. From the CTP Main Menu, select 1) Bundle Operations.
2. Select 1) CTP.
3. Select a bundle from the list.
4. Select 8) Runtime Diags.
5. Configure the BERT options as described in Table 65 on page 165.
Table 65: BERT Parameter Settings in the CTP Menu
Your ActionFunctionField
Select one:
•
Disabled—Disables BERT transmission on this
bundle.
•
Tx to NET—BERT pattern is injected toward the
IP network. User data transmitted in the direction
of the IP network is replaced with the BERT
pattern.
•
Tx to I/F—BERT pattern is injected toward the
serial interface. User data transmitted toward the
serial interface is replaced with the BERT pattern.
Specifies whether this bundle acts as the BERT
transmitter. If the bundle is the BERT transmitter,
specifies the direction in which it transmits test data.
BERT
Injection
Select one:
•
Disabled—Disables BERT reception on this bundle.
•
Rx from NET—BERT pattern is received from the
network.
•
Rx from I/F—BERT pattern is received from the
interface.
Specifies whether this bundle acts as the BERT receiver.
If the bundle is the BERT receiver, specifies the direction
from which it receives test data.
The BERT receiver does not disrupt the existing data
flow in either direction.
BERT
Reception
165Copyright © 2018, Juniper Networks, Inc.
Chapter 7: Configuring Diagnostic Testing for CTP Bundles