Configuring Multiservice IRIG-B Mode Port Parameters for CTP Bundles (CTP Menu)
Before you begin:
•
Disable the bundle before you modify the bundle options.
To configure Multiservice IRIG-B mode port parameters using the CTP Menu:
1. From the CTP Main Menu, select 1) Bundle Operations.
2. Select 1) CTP.
3. Select a bundle from the list.
If you select an active bundle, you are prompted to disable the bundle before
configuring it.
4. Select 3) Port Config.
5. Select 2) Interface.
6. Select 1) Type and set the type to Optional Interface: MultiSvc.
7. Follow the onscreen instructions and configure the options as described in
Table 34 on page 81.
Table 34: CTP Bundle Multiservice IRIG-B Port Parameter Settings in the CTP Menu
Your ActionFunctionField
Select IRIG.Specifies that the bundle will run in
IRIG-B mode.
Mode
81Copyright © 2018, Juniper Networks, Inc.
Chapter 2: Configuring CTP Bundles
To Next Page
Loading...
