Juniper SSG-350M-SH User Manual

Juniper Networks SSG 320M and 350M Security Policy
14
 If a seal must be removed, the surface should be prepared as described above prior to the
application of a replacement seal.
Tamper Seal Placement – SSG320M (5 seals)
Figure 2: Front of the SSG 320M device
Figure 3: Rear of the SSG 320M device (inverted)
Tamper-evident seals should be applied to front of the 320M, as shown in Figure 2 (4 seals):
 One seal vertically (label #1) across the left edge of the leftmost slot cover, extending on to
both the top and front of the chassis.
 One seal vertically (label #2) across the right edge of the leftmost slot cover, extending on to
both the top and front of the chassis.
 One seal vertically (label #3) across the left edge of the rightmost two slot covers, extending
on to both the top and bottom of the chassis.
 One seal vertically (label #4) across the right edge of the rightmost two slot covers, extending
on to both the top and bottom of the chassis.
Tamper-evident seals should be applied to the rear of the 320M, as shown in Figure 3 (1 seal):
 One seal vertically (label #5) across the center of the cover plate, extending on to the bottom
of the chassis.
Tamper Seal Placement – SSG350M (10 seals)

Juniper SSG-350M-SH Specifications

General

Brand	Juniper
Model	SSG-350M-SH
Category	Server
Language	English