To Next PageTo Next Page
Need help?Do you have a question about the Junkers JU-87D Stuka and is the answer not in the manual?
General| Role | Dive bomber |
|---|---|
| Manufacturer | Junkers |
| Service ceiling | 8, 200 m (26, 900 ft) |
| Engine | Junkers Jumo 211J |
| Height | 3.9 m (12 ft 9 in) |
| Armament | 2 × 7.92 mm MG 17 machine guns |
Critical safety guidelines for operating the R/C airplane, including age restrictions and advice.
Key technical details of the JU-87D Stuka model, such as length, span, and weight.
Guidance on adjusting control surface travel for optimal flight performance.
Instructions on checking and setting the correct center of gravity for safe flight.
List of necessary separate purchases for operation and assembly.
Initial steps including reading the manual, checking parts, and understanding symbols.
Steps for drilling holes and attaching bombs, and preparing the center wing.
Adjusting elevator and rudder travel to specified values for flight.
Attaching the cowling using plies and screws, and assembling stabilizer struts.
Securing the canopy with screws and attaching servos to the wing.
Trimming slots, attaching dummy flaps, and mounting servos.
Joining main wings to the center wing using joiners.
Attaching PVC parts, wheel pants, and epoxy plastic parts to the wing.
Mounting landing wire and epoxy dowels on the wing.
Installing rudder and elevator servos, and attaching control horns.
Connecting linkages and mounting the main wing to the fuselage.
Mounting the engine, fuel tank, and associated lines into the fuselage.
Installing the nylon control ring and connecting the linkage for the throttle.
Drilling holes for the engine mount and main wing on the fuselage.
Assembling the throttle linkage, including servo and set screws.
Attaching horizontal tail, vertical tail, and tail gear separately.
Epoxy the rudder to the vertical tail and assemble the tail wheel.
