At 0, the stop time is locked.
The controller will optimize this time.
After a short time, the display will show the maximum stored
flow temperature.
The display and the key flash.
The display shows the flow temperature again.
The off time can be set from 0 to 15 minutes (factory setting: 3
minutes).
B Turn the thermostat knob until
and keep it that way until
Fig. 30
The display and the key flash.
B Press the display
key [ ] appears.
B Turn the thermostat knobs to the values as well
The maximum flow temperature can be set between 45ÿC and
approx. 90ÿC (factory set).
6.2.3 Changing the stop time
.
B Press the key on
the display appears - -
The key flashes.
After a while, the display will show the saved stop time.
The working mode has been saved.
and keep it that way until
22
The display shows the flow temperature again.
Fig. 27
B Turn the thermostat knobs to the values as well
B Write down the value in the commissioning report (page 36).
Fig. 28
The shortest possible shutdown time is 1 minute (recommended
for single tube installations).
When switching on a temperature
controller with an external probe, no change
in the switch-off time is required.
The working mode has been saved.
B Turn the thermostat knob until 2.5 appears on the
display .
The display shows the maximum desired temperature on
the tour, between 45 and about 90 .
Fig. 32
initials.
Fig. 31
B Press the key on
the display appears - -
The key flashes.
(service function 2.4)
The display shows the desired stop time, between 0 and 15 .
B Write down the value in the commissioning report (page 36).
and keep it that way until
6.2.4 Setting the maximum flow temperature (service
function 2.5)
Individual adjustment
B Turn the thermostat knob until 2.4 appears on the
display .
.
and keep it that way until
initials.
B Press the display
key [ ] appears.
B Turn the thermostat knob until
Fig. 29
6 720 610 332-42.1O
6 720 610 332-39.1O
6 720 610 332-34.1O
6 720 610 332-32.1O
6 720 610 332-32.1O
6 720 610 332-34.1O
6 720 610 828 RO (02.01)
i
Machine Translated by Google
To Next Page
Loading...
Need help?
General