Upper and lower limit display interface:
Load the parameters of a position of M1-M9.
Save the parameters to a location in the M1-M9
storage location.
Working hours and ampere hours are cleared.
The address (there are 99 addresses of 01-99),
different addresses represent different host power
supplies, and one-to-many control display is
possible.
Channel (with 01-30 total 30 addresses), different
channels represent different host power supplies,
and which can perform one-to-many control display.
The host address is set to 00, meaning it is not
controlled by any wireless controller.
After the quick discharge is turned on, the response
time of the voltage from high to low is relatively
short.
After the automatic output is turned on, the output
will be automatically turned on when the power is
turned on. ON (on), OFF (off).
When the adjustment voltage
and current reach the upper
limit, it is displayed as MAX.
The upper limit value is the
same as the lower limit value
and it is displayed as LOCK.
To Next Page
Loading...
