16
2 Preparation
2 Preparation
E You can stop the machine at any time while a speciality coffee,
steam or hot water is being prepared. Just press the Rotary
Switch (for a speciality coffee) or return the switch to its origi-
nal position (for steam and hot water).
E During the grinding operation you can select the coffee
strength of single products by turning the Rotary Switch g:
MILD, NORMAL, STRONG or EXTRA.
E During preparation, you can change the preset amount of
water for a speciality coffee by turning the Rotary Switch g.
E You can follow the current status of preparation on the pro-
gress bar.
E The last speciality coffee prepared is always displayed, even if
the IMPRESSA was switched off in the meantime.
Coffee tastes best served hot. A cold porcelain cup cools the bever-
age – and impairs the taste. We therefore recommend prewarming
the cups. The full coffee aroma can develop only in prewarmed cups.
You can purchase a JURA cup warmer from your specialised dealer.
You can make permanent settings for all products in programming
mode (see Chapter 4 ‘Permanent settings in programming mode –
Product settings’).
Espresso and coffee are both prepared following this model.
Example:Proceed as follows to prepare one coffee.
Precondition:
ESPRESSO is displayed (example).
T Place a cup under the coffee spout.
g T Turn the Rotary Switch until
COFFEE is displayed.
k T Press the Rotary Switch.
Preparation starts.
COFFEE and the coffee strength are
displayed. The preset amount of water for coffee flows into
the cup.
Preparation stops automatically.
COFFEE appears on the
display.
Espresso and coffee