Calibrating the milk level display
The milk level is calculated based on weight. For
this reason, you must calibrate the built-in scales.
T Remove the stainless steel container with its
cover from the Cool Control.
T Press the On/Off button Q to switch on the
Cool Control.
T Press the calibration button for
sec.
until an acoustic signal sounds.
Preparing the stainless steel container
T Insert the metal tube into the adapter.
T Position the adapter on the edge of the
stainless steel container.
Cooling milk
T Insert the stainless steel container into the
Cool Control.
T Fill the stainless steel container with cold
milk.
T Use the cover to close the stainless steel con-
tainer.
T Connect the milk pipe of the coffee machine
to the adapter.
E To connect the milk pipe to the adapter
correctly, the pipe must be fitted with a
connector.
T Press the On/Off button Q to switch on the
Cool Control.
E To save energy, the cooling process stops as
soon as the stainless steel container is
removed from the Cool Control.
E To switch off the Cool Control, press the On/
Off button Q.
E If you want to shut down the machine,
remove the mains plug from the power
socket.
Information about using the Cool Control
E Do not place anything on top of the Cool
Control. This will interfere with the built-in
scales for calculating the milk level.
Milk temperature:
U
below the ambient temperature but not below
U
Underneath the machine cover is the milk
temperature display. You can choose between
°C and °F. To switch between the two displays,
press the calibration button.
After preparation, an acoustic signal sounds and
the milk level display lights up red:
U
Add cold milk to the stainless steel container.
To Next Page
Loading...
