2
D6 – Quick Reference Guide
D6 – Quick Reference Guide
J
These short instructions do not replace the ‘D6 Instructions for Use’.
Make sure you read and observe the safety information and war-
nings first in order to avoid hazards.
Ten minutes after milk preparation, the D6 prompts you to perform
milk system rinsing.
Precondition:
M-RINSE / CAPPUCC. is displayed (example).
T Place a receptacle under the fine foam frother.
T Touch the Maintenance symbol c for approximately
2 seconds until
OPEN SWITCH appears.
T Turn the switch to the m position.
The fine foam frother is rinsed.
CLOSE SWITCH
T Turn the switch to the ° position.
CAPPUCC. (example)
To ensure that the fine foam frother always works properly, you
must clean it daily when you have been preparing milk
If the wrong cleaning agent is used, the machine could be damaged
and/or traces could be left behind in the water.
T Use only original JURA maintenance products.
E JURA milk system cleaner is available from specialised dealers.
Precondition:
CAPPUCC. is displayed (example).
T Touch the P symbol for approximately 2 seconds until
RINSE appears on the display.
T Press the Rotary Switch to enter the programme item.
M-RINSE
T Turn the Rotary Switch until M-CLEAN is displayed.
T Press the Rotary Switch.
CLEANER / WATER
T Remove the milk pipe from the milk container or milk cooler.
Rinsing the fine foam
frother
Cleaning the fine foam
frother
CAUTION
To Next Page
Loading...
Need help?
General
