3
D6 – Quick Reference Guide
T Pour 250 ml of fresh water into a receptacle and add 1 capful
of milk system cleaner.
T Immerse the milk pipe in the receptacle.
T Place a receptacle under the fine foam frother.
T Press the Rotary Switch.
M-CLEAN, OPEN SWITCH, the light segment on the
switch lights up.
T Turn the switch to the m position.
The fine foam frother and the milk pipe are cleaned.
CLOSE SWITCH
T Turn the switch to the ° position.
WATER
T Rinse the receptacle thoroughly, fill it with 250 ml of fresh
water and immerse the milk pipe in the water.
T Empty the other receptacle and place it under the fine foam
frother once more.
T Press the Rotary Switch.
OPEN SWITCH
T Turn the switch to the m position.
The fine foam frother and the milk pipe are rinsed with fresh
water.
CLOSE SWITCH
T Turn the switch to the ° position.
CAPPUCC. (example)
To make sure the fine foam frother works properly, and in the inte-
rests of hygiene, it must be dismantled and rinsed daily if you have
been preparing milk. Your D6 will not prompt you to dismantle and
rinse the frother.
T Remove the milk pipe and rinse it thoroughly under running
water.
T Carefully remove the fine foam frother from the Connector
System
©
by twisting slightly.
Dismantling and rinsing
the fine foam frother
To Next Page
Loading...
