Jura ENA Micro 9 One Touch - Page 3

Elektroapparate AG
Disassembling manual
Technical Support
Language
EN
ENA Micro 9 One Touch
Author: Patrik Studer
Checked:
Approved:
Docu.-name: Demontage_ENA_Micro_EN.doc
L:\Geräte\ENA\ENA_Micro\ENA_Micro_9\Schulungsunterlage
n\E\Demontage_ENA_Micro_EN.doc
Date:
Rev. A:
Rev. B:
Rev. C:
Rev. D:
Rev. E:
Rev. F:
06.10.2011
11.11.2011
Page 3/15
5. Push with a small screw driver (no. 0) or alike
simultaneous in both immersions of the interlock
(between both lateral- and front parts)
6. Remove cover of the service plug
7. Insert e.g. a plastic ruler in between the bottom
and lateral part to release the barb
(approx. 7 cm of distance)
8. On the same, upper side, pull outside the lateral
part with your thumb (or similar aid).
Pull backwards the whole lateral part.
Proceed the same way for the other lateral
part.
9. Position of the lower barb of the lateral part
10. Position of the upper barb of the lateral part