12
1 Preparing and using for the first time
T Fill the water tank with fresh, cold water and reinsert the
tank.
T Press the ‘Next’ button.
‘Switch open’
T Place a receptacle under the hot-water spout and dual spout.
l T Turn the switch to them position.
‘Filter is being rinsed’, water flows out of the hot-water
spout.
E You can interrupt rinsing of the filter at any time. To do this,
turn the switch clockwise. Turn the switch anticlockwise to
continue rinsing the filter.
E The water may be slightly discoloured. This is not harmful to
health and does not affect the taste.
Rinsing of the filter stops automatically after approximately
300ml. ‘Switch close’ appears on the display.
y T Turn the switch to the °position.
‘System is filling’, the system fills up with water.
‘Machine is heating’, the machine heats up.
‘Machine is rinsing’, the system is rinsed. The rinse stops
automatically. ‘Please select product’ appears on the display.
Your JURA F9 is ready for use.
E The display shows the products you can prepare.
Milk, sparkling mineral water or other liquids can damage the water
tank or the machine.
T Only fill the water tank with fresh, cold water.
T Press the ‘Inactive’ button.
T Press the ‘Save’ button.
‘Saved’ appears briefly on the display.
‘Water hardness’
E If you do not know the hardness of your water, you must find
this out first (see Chapter 1 ‘Preparing and using for the first
time – Determining the water hardness’).
First-time use without filter
cartridge activation
CAUTION
To Next Page
Loading...
Need help?
General
