17
E
16. Messages
Display Cause Action
– System empty – Fill system (see point 4.1)
– System too hot after drawing off steam – Reset to coffee stand-by
– Wrong position of selector switch – Put selector switch into correct position
– General troubles 1. – Switch off
– disconnect from mains
– connect to mains
– switch machine on
2. Have machine examined by Jura service
centre
– Machine needs rinsing Rinsing the machine
– The tank is empty – Fill with water
– Floater defective – Rinse out or de-scale water tank
– Grounds container full – Empty grounds container
– Tray replaced too early after emptying – Only replace the tray after about 10 sec.
To Next Page
Loading...
