Jura IMPRESSA Z9 One Touch TFT - Changing the Filter

43
5 Maintenance
E After 2000 oz (60 liters) of water have flowed through, the
filter will cease to work. Your IMPRESSA will automatically
prompt you to change the filter.
E After three months, the filter will cease to work. Set the date
on the date plate on the filter holder in the water tank.
E If the CLEARYL Blue filter cartridge is not activated in program-
ming mode, you will not be prompted to change the filter.
E CLEARYL filter cartridges are available from specialized
dealers.
Precondition:
‘Change the filter’ is displayed and the P buttonlights
up.
 O T Press the P button.
‘Maintenance status(1/7)’
T Press the ‘Change the filter’ button.
‘Approximate duration 2 min.’
T Press the ‘Start’ button.
‘Use only original JURA maintenance products!’
T Press the ‘Start’ button again.
‘Change filter.’
T Remove and empty the water tank.
T Open the filter holder and remove the old CLEARYL Blue
filter cartridge.
T Fit the filter extension on top of a new filter cartridge.
T Insert the new filter cartridge into the water tank, exerting
slight pressure.
T Close the filter holder. It will click into place audibly.
E After three months, the filter will cease to work. Set the date
on the date plate on the filter holder in the water tank.
T Fill the water tank with fresh, cold water and reinsert the tank.
T Place a receptacle (at least 17 oz or 500 ml) under the
cappuccino frother.
T Press the
‘Next’ button.
‘Filter is beingrinsed.’, water flows out of the cappuccino
frother.
E You can interrupt rinsing of the filter at any time by pressing
any button. Press the Rotary Switchk to continue rinsing of
the filter.
Changing the filter