REV
20-01-2020
INSTALLATION
,
USE AND MAINTENANCE MANUAL
–
HELIX 220-300-450-750-1200-1500-2000
4 / 60
Via Crosera n° 50
33082 Azzano Decimo, PN (Italia)
EL
AX
http://www.jurop.it
e-mail: info@jurop.it
1.1. Introduction
• This booklet contains the necessary instructions for a correct
installation, running, use and maintenance of the compressor, as well
as some practical suggestions for a safe operating.
• The knowledge of the following pages will grant a long and
trouble-free operation of the compressor.
• Following the instructions below contributes to limiting pump repair
expenses by extending its duration, as well as preventing hazardous
situations, thereby increasing its reliability.
• If the pump is driven by an hydraulic motor please refer to
manufacturer's specific manual.
• It is recommended to:
- Understand and apply carefully the instructions before running the
pump.
- Keep the booklet at hand and have it known to all operators.
• Below is a brief description of the symbols used in this manual.
If these safety rules are not respected, operators can be
injured and the compressor or oilers damaged remarkably.
If these safety rules are not respected, the compressor or
system can be damaged.
Suggestions for an environment friendly use of the
compressor.
Useful information for an easy usage and maintenance of
the compressor.
• The graphic representations and photographs contained in this
manual are there to illustrate the product in the parts that make it up
and in specific operating phases. Though the model shown in the
manual may differ from the one purchased, the operating principle at
the base of the illustrated operating phase is the same.
• Each HELIX shows a manufacturer plate that specifies:
1. HELIX Model
2. Serial Number
3. Year of manufacture
4. Max Pressure
5. Maximum speed at maximum vacuum rate
6. Maximum speed at vacuum ratee equal of 80%
7. Maximum required power
Pic. 1.1
1.2. Spare part request
• Use only genuine spare parts for maintenance and repairs. To
order spare parts, provide the following details:
EXAMPLE:
a) The model of the compressor (see compressor tag) HELIX
750
b) The serial number of the compressor (see compressor tag) J000001
c) A description of the parts (see parts list) SPACER
d) The quantity (see parts list) 1
e) The code number of the part (see parts list) 16240 393 00
1.3. Warranty terms and conditions
• Compliance with the installation, use and maintenance instructions
provided by this manual is crucial for the recognition of warranty
against defective parts.
To Next Page
Loading...
