Installing the JUWEL Automatic Feeder
1. Pull container C to the outside
2. Remove cover A and insert feed. The feed should not be compressed in order to
ensure its even release.
3. Close the container with cover A and re-insert the container in such a manner that
it audibly clicks into position.
4. As detailed in "Installation", please place the automatic feeder above the opening
of the feeder hole.
It is possible to connect the JUWEL automatic feeder to an air pump in order to keep
the food dry.
Adjusting the feed quantity:
You may adjust the quantity of food released by means of controller B.
Service and Maintenance of the JUWEL Automatic Feeder
The JUWEL automatic feeder requires very little maintenance.
You should clean feed container C and the surrounding area at regular intervals.
When replacing the batteries, check the contacts are clean and dry.
4
To Next Page
Loading...
