juwel MultiLux LED - Introduction; Safety instructions:; MultiLux LED light unit; Installation of the MultiLux LED light unit

Introducon
Thank you for choosing a JUWEL Aquarium product.
Our products represent over 50 years experience in the manufacturing of aquariums and their acessories applying most modern
producon techniques bringing together the JUWEL Aquarium system, which is both easy to use and simple to maintain.
Please read this instrucon manual carefully and completely to make sure you have received all components before seng up the
aquarium. Please observe the safety instrucons and maintenance guidelines given in this manual.
This instrucon manual has been carefully prepared to provide you with accurate and complete informaon. All efforts have been
made to ensure that the informaon given is correct. However, we cannot accept responsibility for prinng or other errors.
Technical details are always approximate and are not warranted characteriscs and may be subject to change without noce.
This product fulfils the guidelines issued by the European Union (EU) and is therefore entled to carry the CE mark.
www.juwel-aquarium.de/en/declaraon-of-conformity/
MulLux LED light unit
The MulLux LED is a high-performance LED light unit for your aquarium. The replaceable LED tubes enable maximum lighng of
your aquarium and ensure an energy saving of up to 50% compared to T5 fluorescent lamps.
The light unit itself is waterproof and therefore allows you to maintain your aquarium with full lighng.
Installaon of the MulLux LED light unit
Safety instrucons:
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilies or lack of
experience and knowledge if they have been given supervision or
instrucon concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children without supervision.
•
The power plugs of the electrical devices must not become moist. Connect
the power plugs to the power supply at such a height that the connecon
cable forms a loop which would enable the water to drip down.
•
At all mes, only operate the electrical devices for your aquarium (lighng,
heater, pump etc.) using an earth leakage circuit breaker (EL circuit
breaker) with a maximum tripping current of 30 mA. If the socket that you
are using in your home installaon is not safeguarded with such a circuit
breaker, please use a commercially available power strip with an integrated
earth leakage circuit breaker.
•
The electrical devices may only be operated in rooms.•
Pull the power plug of all devices operated in water before coming into
contact with the water.
•
The water ghtness can only be guaranteed if the tube holders
have been firmly connected to their sockets and we recommend
that you check this prior.
The MulLux LED light unit may now be placed on the top
frame of the aquarium and connected to the power supply.
Then, aach the flaps and close the aquarium.
In that context, ensure that the top frame of the aquarium and
the guide rails of the cover hatches are free of foreign objects,
e.g. sand or gravel.
2