juwel MultiLux LED - Notice:; Maintenance and Care of the MultiLux LED light unit; Safety notices:

Noce:
If a defect occurs on the MulLux LED light unit, it switches itself off automacally.
If a replacement of both LED tubes does not make the light funcon again, we recommend that you purchase a new light unit,
which is available as a spare part.
Maintenance and Care of the MulLux LED light unit
The JUWEL Aquarium MulLux LED light unit requires lile
care and maintenance. Only clean the frame with a so cloth
and warm water.
Changing the LED tubes:
In order to fault-free funconality of the light unit, it is
absolutely necessary to disconnect the power plug prior to
replacing the LED tubes!
Only reconnect the MulLux LED to the power supply aer this!
Unscrew the tube holders and slide them over the LED
tube.
1.
Remove the LED tubes from the fings.2.
Prepare the new LED tube for use by sliding the tube
holders over the tube.
3.
Insert the new LED tube into the fing as shown in the
illustraon. Check the correct posion.
4.
Screw the tube holders on ghtly.5.
Switch the light unit back on.6.
Safety noces:
LED module – do not look into the light source! Risk Class 2•
Never stare directly into the source of light for any period of me as you
will otherwise risk damaging your eyes.
•
Pull the power plug for each LED tubes replacement.•
The connecon line may not be repaired. Always replace the enre light
unit in case of damage.
•
Do not operate the light unit under water.•
Do not aempt to open the light unit or repair it in case of a malfuncon!
This would endanger the water-ghtness.
•
The JUWEL LED tubes are coordinated with the electronic components of
the MulLux LED light unit. Therefore, only use these LED tubes as
original JUWEL Aquarium spare parts.
•
3