JVC CA-HXZ1 - Common Operations; Powering On;Off and Setting Clock

CommonOperations
Continued
TurningOnor Offthe Power
To turn on the unit, press O/I (or [_]
STANDBY/ON OIl on the remote control)
so that the lamp on the button goes off.
FI I--II I II_, H I_ R i--II,
_ LI I_1
To turn off the unit (on standby), press Oil
(or STANDBY/ON _/I on the remote control)
again so that the lamp on the button lights up.
• A little power is always consumed even while
the unit is on standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "0:00" right away, while the tuner preset
stations (see page 13) will be erased in a few days.
SavingthePowerConsumptionwhileonStandby
--Ecology Mode
You can save the power consumption while the unit is turned
off (on standby).
• You can set Ecology Mode whether the unit is on or off.
On the unit ONLY:
To activate the Ecology Mode, press ECO.
"ECO" appears on the display for 2 seconds (and
demonstration is canceled temporarily if you
have pressed the button while the unit is off).
• Each time you press the button, "ECO" and "NORMAL"
appear alternately on the display.
To deactivate the Ecology Mode, press ECO again.
"NORMAL" appears (and demonstration starts if the unit is
turned off).
_When you turn off the unit with Ecology Mode activated
"ECO" flashes on the display, and the clock time will not be shown
while the unit is turned off.
Setting the Clock
You can set the clock whether the unit is on or off; however,
if Ecology Mode is activated, you cannot set the clock while
the unit is off. "0:00" flashes on the display until you set the
clock.
On the unit ONLY:
1Press CLOCK/TIMER. IZ_::I_ ,_°_7_
Thehour digits start flashing on the display.
.........LI"
2 Turn I_ / _ to adjust the ...........
hour, then press SET/DISPLAY. _//__"_
The minute digits start flashing on the
display.
, @-, .......
I ..........I-I: .....
If you want to correct the hour cA.o.......
after pressing SET/DISPLAY, _k-._',,
press CANCEL/DEMO. \
The hour digits start flashing again.
SET/
DISPLAY
%
3 Turn I_,_ / _ to adjust the minute, then
press SET/DISPLAY.
El '-' I'< I'<LIE '-'
To checkthe clock time
Press and hold SET/DISPLAY while playing any source.
• Each time you press and hold the button, the source
indication and the clock time alternate on the display.
To adjust the clock again
If you have set the clock before, you need to press
CLOCK/TIMER repeatedly until the clock setting mode is
selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
F DALLY--_ TIMER "-_ REC j
(Daily Timer setting)
L_ Canceled --,-- -"-- TIMER
(Recording Timer setting)
(The hour digits start flashing,)
When you unplug the AC power cord or if a power
failure occurs
The clock loses the setting and is reset to "0:00." You need to set the
clock again.
-10-