JVC CA-MXJE3 - Timer and Sleep Functions; Setting the System Clock; Automatic Power Off (Sleep Timer); Checking Sleep Timer Status

15
Setting the Clock
Without setting the built-in clock, you cannot use Daily/
Recording Timers (see page 29) and Sleep Timer (see
below).
• To exit from the clock setting, press CLOCK/TIMER as
required.
• To go back to the previous step, press CANCEL/DEMO.
1
Activate clock setting mode.
• If you have already adjusted the clock before, press the
button repeatedly until the clock time starts flashing.
2
Adjust the hour, then minute.
Now the built-in clock starts working.
To check the current time when the System is turned on
Turning Off the Power Automatically
With Sleep Timer, you can fall asleep listening to music.
1
Specify the time (in minutes).
2
Wait until the set time goes off.
To check the time remaining until the shut-off time
INFO
Main Unit
ONLY
CLOCK
/
TIMER
SET
/
DISPLAY
PRESET
SET
/
DISPLAY
Clock
Source information
2 sec.
Remote
ONLY
SLEEP 10 SLEEP 20 SLEEP 30 SLEEP 60
SLEEP 90SLEEP 120
SLEEP 150Canceled
SLEEP
• If you press the button repeatedly, you can
change the shut-off time.
Basicop.fm Page15 Thursday,January13, 2005 3:39 PM