OPERATIONS
39
ENGLISH
Using the Bluetooth audio player
*
1
Each time you press 5 ∞, the registered device
names (and “NEW DEVICE” when a new device can
be registered) appear in turn. You cannot select “New
Device” when a Bluetooth audio player is connected.
*
2
Appears only when the information comes from the
device.
*
3
Indicates the button pressed. It may be different from
the operation status.
*
4
When a cellular phone with audio function is
connected, appears.
You can use the following buttons on the remote
controller for the Bluetooth audio operations. For
details, ☞ pages 8 and 9
15: 45
FLAT
Connected Device Name
Bluetooth Audio
POWER]ON
Pause
Reverse/forward skip
*
1
Status of the device*
2
Signal strength/Battery remainder
☞ page 48
List menu icon
AV Menu
Setup
Enter
ENT
AV Menu
List
Enter
ENT
~ Select “Bluetooth Audio.”
Ÿ Start playback.
• See pages 33 to 35 for connecting a new device.
• See page 35 for connecting/disconnecting a
registered device.
• See page 35 for deleting a registered device.
When the sound is stopped or interrupted during
the use of a Bluetooth device, try the following
remedies.
• Turn off, then turn on the unit.
• (When the sound is not yet restored,) connect the
device again. (☞ “Connecting/disconnecting a
registered device” on page 35)
You can use the following buttons on the remote
controller for the Bluetooth phone operations. For
details, ☞ pages 8 and 9.
• Preset List can also be accessed through <AV
Menu> = <List>.
*
3
Turns Blue when the Bluetooth
device is connected.
*
4
Bluetooth Information:
If you wish to receive more information about
Bluetooth, visit our JVC web site.
KD-AVX33[E]_0130.indb 39KD-AVX33[E]_0130.indb 39 07.2.1 4:44:27 PM07.2.1 4:44:27 PM
To Next Page
Loading...
