56
ENGLISH
Equalizer
Flat/Hard Rock/R&B/Pop/Jazz/Dance/Country/Reggae/Classic/User1/User2/User3, ☞ [48]
Sound
Menu items Selectable settings, [reference page]
Fader/Balance Adjust fader—speaker output balance between the front and rear speakers.
• Upmost—front only
• Downmost—rear only
When using a two-speaker system, set the fader to the center (00).
Adjust balance—speaker output balance between the left and right speakers.
• Leftmost—left only
• Rightmost—right only
Volume Adjust Adjust and store auto-adjustment volume level for each source, comparing to
the FM volume level. The volume level will automatically increase or decrease
when you change the source.
–12 to +12; Initial 00
Subwoofer*
14
Adjust the settings below in the submenu:
Phase : Subwoofer phase. Select either <Normal> or <Reverse>, which
reproduces a better sound.
Level : Subwoofer output level. Level: –06 to +08; Initial 00
High Pass Filter Through : Select when the subwoofer is not connected.
On : Select when the subwoofer is connected.
Crossover Adjust the crossover frequency between the front/rear speakers and the
subwoofer.
80Hz, 120Hz, 150Hz
Amplifier Gain You can change the maximum volume level of this unit.
Off : Deactivates the built-in amplifier.
Low Power : VOL 00 to 30 (Select this if the maximum power of the speakers
is less than 50 W.)
High Power : VOL 00 to 50
Rear Speaker*
15
You can activate/deactivate the rear speakers.
Off, On
*
14
This subwoofer level setting takes effect only when surround is deactivated. (☞ also page 24, 25)
*
15
This setting takes effect only when Dual Zone is activated. (☞ also page 28)
Adjusts fader
Adjust balance
KD-AVX33[E]_0130.indb 56KD-AVX33[E]_0130.indb 56 07.2.1 4:44:39 PM07.2.1 4:44:39 PM
To Next Page
Loading...
